Product ID: T04-0032L

Auto Glass Tools For Wire Hold ( T04-0032L)

Auto tester for wire hold

Ordering information

FOB:Taiwan

or

Features:

• The long, narrow shaft protects the dash and interior mouldings from being damaged. Run the wire through the hole at the end of the tool.
• Then, with the wire on the round side of the tool, attach the end of the wire in the hole midway up the tool, locking it in place with the set screw.
• Move the tool on the inside of the vehicle, a few inches at a time, while the person on the outside follows doing the cutting.
• The smooth metal will move under the mouldings and along the dash and prevent damage. It can also be used on the outside where the urethane is far below but above the bottom edge. Use this tool to change the direction of the wire and cut inaccessible urethane.